MA6002
160-watt, two-channel marine amplifier
Sold from 2006 until now
| Made in: | China |
|---|
Documents & Downloads
Product Specifications
- Type
- 2-Channel
- Series
- Marine
- Input Sensitivity
- 100mV
- Signal-to-Noise Ratio
- 84 dBA (reference 1W into 4 ohms)
- Dynamic Power Output
- 160W at 2 ohms
- Frequency Response
- (-3dB) 10Hz-27Hz
- Damping Factor
- 6.395 at 4 ohms
- Dynamic Power Output
- 160W at 2 ohms
2-Channel Full-Range Marine Amplifier with electronic crossover, variable bass boost and preamp outputs.
With a marinized circuit board, stainless steel hardware and all the right waterproofing, the MA 6002 is, like all JBL® marine audio products, built to survive salt water, corrosion and other risks – and show you a great time out there.
The MA6002 comes equipped with a 12dB Per Octive Electronic Crossover. This provides a high level of tunablity and allows for different speakers and can be selected as either a high-pass or low-pass.
You may have your choice of where to install it or you may not. A variable bass-boost circuit provides additional bass tuning to optimize performance, regardless of where it lives.
Owning a boat takes commitment and work. Installing the JBL® MA 6002? Not so much. It’s also pretty compact at 9 by 10-1/4 by 2-3/16 inches with a low profile heat sink. You can put it in the tightest of spots.
The JBL® MA6002 has output of 145 watts RMS and peak power handling of 160 watts. You can fill the fresh, open air with great sound.
The MA6002 is also equipped with a variable bass boost circuit. There is a total of 6dB of boost available centered at 45Hz.
Images & Videos
Can’t find what you’re looking for?
Chat with Us
Mon-Fri 8:00 AM to 5:00 PM (AEST)
