_dvHAMaster.png?sw=960&sh=960&sm=fit&sfrm=png)
Kappa 62.9i
6-1/2" Two-Way Loudspeaker
Downloads
Product Specificaties
- Power Handling (Continuous/Peak)
- 75W/225W
- Impedance
- 2 Ohms
- Sensitivity
- 95dB
- Frequency Response
- 45Hz - 25kHz
- Diameter (in)
- 6-1/4"
- Depth (in)
- 3-1/8"
- Mounting Diameter (in)
- 5-1/8"
- Mounting Depth (in)
- 2-5/16"
6-1/2 inch 2-way car audio loudspeaker with Plus One® woven- glass-fiber-woofer cone and edge-driven MMD®-dome tweeter.
This patent pending technology deliver a cone with more surface area than competing models of the same size. The result is increased bass output and higher efficiency.
These are not commonly used W-domes, but fully edge driven domes like those found in fine home audio loudspeakers. This much larger voice coil increases power handling and provides better sonic integration with the mid-woofer.
To ensure proper imaging the 62.9i utilizes a patented rotating tweeter (patent no. 6,002,780). So even if the speaker is mounted down low in the door, the soundstage can be brought up and optimized for the listener's location.
Allows for installation of the 62.9i in all 6-1/2" hole size standards without the need to purchase additional adaptors or mounting kits.
Woven glass fiber woofer cone material is extremely stiff, minimizing cone flex which yields very low distortion and improved clarity, an Infinity trademark.
All Kappa speakers feature two ohm voice coils. Original factory-installed speaker wiring in many cars is 18-22 gauge. This wire, and heating in the voice coil when power is applied, increase the impedance “seen” by the amplifier or head unit. The impedance of Kappa Speakers has been adjusted to compensate for this increase and can be safely driven by any head unit.
Each Kappa multielement and component system features an outboard crossover that has been voice-matched for flawless performance with incredible detail and accuracy.
Each Kappa multielement features a user adjustable tweeter level control. On the two-way models, simply rotate the tweeter to add or subtract 3dB output. On the three-way models, it is the simple push of a button right on the tweeter faceplate.
Afbeeldingen en video's
_dvHAMaster.png?sw=300&sh=300&sm=fit&sfrm=png)
_dvHAMaster.png?sw=300&sh=300&sm=fit&sfrm=png)
_dvHAMaster.png?sw=300&sh=300&sm=fit&sfrm=png)
_dvHAMaster.png?sw=300&sh=300&sm=fit&sfrm=png)
Kan je niet vinden wat je zoekt?
Bel onze support-afdeling
Bel ons nu op:
+32 (0) 28080136
Maandag - Vrijdag: 09.00-18.00
Zaterdag - Zondag: 10:00-16:00
Stuur een email aan onze support-afdeling
We zijn er van maandag t/m zondag om je vragen zo snel mogelijk te beantwoorden!
Stuur ons een email
Chat met onze support-afdeling
Chat is open op werkdagen tussen 09:00 en 18:00 en van 10:00 - 16:00 in het weekend.
WhatsApp Ons
Stuur ons een bericht hier
Maandag - vrijdag: 09.00-18.00Zaterdag - Zondag: 10:00-16:00