Présentation du centre d’assistance / Automobile et marine / Composants électroniques pour voiture / Amplificateurs / Amplifiers (mono/sub) / Reference 1300a

Reference 1300a

300-Watt Mono Subwoofer Amplifier

Vendu à partir de 2007 actuellement

Produit prédécesseur:	REFERENCE 311A
Fait en:	China

Documents et téléchargements

Modes d’emploi

Autre

Caractéristiques du produit

Caractéristiques Générales

Input Sensitivity: 100mv

Signal-to-Noise Ratio: >85dB (ref 1W output @ 4Ω)

Effective damping factor: 6.3 at 4 ohms

Dynamic power: 342 watts at 2 ohms

CEA Rated: Yes

Amplifier Power (RMS): 200 watts x 1 channel @ 4 ohms and ≤1% THD + N

Signal-to-Noise Ratio: 85dBA (reference 1 watt into 4 ohms)

Dynamic Power: 342 watts @ 2 ohms

Effective Damping Factor: 6.3 @ 4 ohms

Frequency Response: 11Hz – 330Hz (-3dB)

Maximum Input Signal: 6V

Input Sensitivity: MAXIMUM... 100mV

MSRP U.S.: $229.95 each

300-Watt mono subwoofer amplifier with on-board electronic crossover and variable bass boost circuit.

Class d subwoofer amps

Efficiency is the benefit of the Infinity Reference Series Class D subwoofer amplifiers. A higher percentage of the power the amp extracts from the car’s charging system is converted into output to the speakers, and less is wasted as heat. That is really important if you're trying to provide power to a 1000-watt amplifier. Class D technology turns the analog input signal into a series of pulses that can be amplified more efficiently by transistors used as switches, rather than valves. They're either on and operating at their most efficient level, or they’re off. The pulses are converted back into an analog signal by an output filter.

Cea-2006-compliant

All Infinity amplifiers are tested in accordance with CEA-2006, which provides a testing procedure to help customers compare amplifiers accurately – apples to apples. Specs are based on industry-accepted standards, rather than on the whims of amplifier companies’ marketing departments. Look for the CEA-2006 logo when comparing amplifiers, to be sure you’re getting the power you’re paying for.

Audiophile-quality Full-range amplifiers

Class AB full-range amplifiers offer audiophilequality performance and the best compromise between efficiency, low distortion, maximum available headroom and output power.

Amps that don’t break

Infinity amplifiers are tested according to the strictest and most demanding reliability-testing regimen ever designed for car audio amplifiers. They are shaken, baked, frozen, dropped and shocked – all while they’re operating. When they’ve passed all these tests, they are tested again. The result is a series of amplifiers that just don’t break.

Dbo bass-optimization circuit

provides superior control and adjustability, compared to traditional bass-boost. DBO is a 2nd order high-pass filter that can be adjusted between 20Hz and 80Hz. The boost (or Q) adjustment boosts the signal above the highpass filter frequency. Used with a sealed box, it can help to increase output for more “fun” if it’s set to about 45Hz. If it’s used with a vented box, it should be set at or slightly below the tuned frequency of the box. That will prevent woofer unloading, and provide more output at the frequency where the box is tuned and the woofer’s excursion is minimized – where it can handle more power.

Included remote level control

The amount of bass in popular recordings differs greatly from track to track. Give your customer as much control as you see fit with the RLC. It varies the output of the amplifier from no output up to the maximum output level that you set with the input sensitivity control.