Présentation du centre d’assistance / Automobile et marine / Enceintes pour voiture / Multi-élément / Reference 5022i

Reference 5022i

5-1/4" two-way loudspeakers with Plus One® woofer cone and edge-driven dome tweeter.

Documents et téléchargements

Modes d’emploi

Notice d'utilisation (Anglais) 1.67 MB

Caractéristiques du produit

Caractéristiques Générales

Type: 5-1/4" 2-Way

Power Handling, RMS: 45W

Power Handling, Peak: 135W

Caractéristiques Audio

Nominal Impedance: 2.65 Ohms

Frequency Response: 67Hz-21kHz

Sensitivity (@ 2.83V, 1m): 92dB

Dimensions

Mounting Depth: 2-1/4"

Depth: 2-7/8"

Diameter: 5-1/8"

5-1/4" two-way loudspeaker with Plus One® woofer cone and edge-driven dome tweeter.

Plus One® woofer cones

This patent pending technology deliver a cone with more surface area than competing models of the same size. The result is increased bass output and higher efficiency.

True Four Ohms

All Reference speakers feature two ohm voice coils. Original factory-installed speaker wiring in many cars is 18-22 gauge. This wire, and heating in the voice coil when power is applied, increase the impedance “seen” by the amplifier or head unit. The impedance of Reference Speakers has been adjusted to compensate for this increase and can be safely driven by any head unit.

Edge-driven textile dome tweeters

These are not commonly used w-domes, but fully-edge-driven domes like those found in better home audio speakers. The benefit is increased power handling and reduced distortion at high output levels. This technology also allows for better integration with the mid/woofer.

Unipivot™Tweeters

Allows the tweeter to be pointed at the listeners location even when the speaker is mounted off axis. This optimizes the stereo image and ensures a more uniform response.

Tweeter level adjustment

The 5022i also features a tweeter level adjustment located on the front of the speaker and can be set at the reference level of 0dB. If the speakers are located low in the doors or if you are looking for a brighter sound, set the tweeter at +3dB