JBL Vibe 300TWS
Totalt trådløse øretelefoner
Sold from 2022 until now
Getting started with your JBL Vibe 300TWS
Quick Start Guide
Get up and running in no time with our easy-to-follow Quick Start Guide
Register your product
Do you own this product? Register it here! And claim your warranty or service easily
Register nowDocuments & Downloads
Specifications
- Enheds-størrelser (mm)
- 12
- Enheds-følsomhed ved 1kHz/1mW (dB)
- 105
- Dynamisk frekvensområde (Hz)
- 20 Hz – 20 kHz
- Impedans (ohm)
- 32
- Antal dynamiske enheder pr. øre
- 1
- Vægt (g)
- 7.7
- Vægt (oz)
- .27
- Bluetooth-profiler
- A2DP V1.3 AVRCP V1.6 HFP V1.7
- Bluetooth-frekvens
- 2.4 GHz - 2.4835 GHz
- Bluetooth sender-modulation
- GFSK, π/4–DQPSK, 8–DPSK
- Bluetooth sender-effekt
- <12 dBm
- Bluetooth-version
- 5.2
- Charging case battery life (max hours)
- 20
- Ladetid (timer fra helt afladet)
- 2
- Maksimal spilletid (timer)
- 6
- Bluetooth
- Ja
- Charging cable
- Ja
- Stemmeassistent
- Ja
- Indbygget mikrofon
- Ja
- Smart opladningsetui
- Ja
- Håndfri opkald
- Ja
- Genopladeligt batteri
- Ja
- Lynopladning (5 min. = 1 t spilletid)
- Ja
- Svedsikre
- Ja
- Touch-knapper
- Ja
- Ægte trådløse
- Ja
- Trådløse
- Ja
- IPX-rating
- IPX2
Totalt trådløse øretelefoner
Hold styr på din verden. JBL Vibe 300TWS-ørestykkerne giver dig din musik, mens du fastholder kontakten med dine omgivelser - uden ledninger, der holder dig tilbage. Nyd 26 timers kraftfuld lyd beriget med JBL Deep Bass. Hold kontakten, mens du er på farten, med stereosamtaler uden irriterende baggrundsstøj. Styr lyd og opkald med én eller begge øretelefoner takket være de praktiske touch-knapper. Det ergonomiske design passer diskret og behageligt i dine ører, så du holder forbindelsen hele dagen - uden at gå glip af et eneste beat eller en samtale.
En kraftig 12 mm-enhed leverer JBL Deep Bass-lyd, så du ikke bare hører musikken. Du føler den.
Gå aldrig glip af noget med 26 timers kombineret spilletid (og 6 timer i ørepropperne). Får du brug for ekstra strøm, kan du lynoplade en hel times batteritid på blot 15 minutter og oplade helt i løbet af 2 timer.
Mikrofonen i Vibe 300TWS-ørestykkerne fjerner baggrundsstøj, så du kan nyde samtaler i stereokvalitet på farten. Lyd og samtaler styres let og håndfrit direkte fra øretelefonerne!
Du kan nemt og når som helst skifte mellem stereo og mono i venstre, højre eller begge øretelefoner, mens du foretager opkald, nyder musik eller taler med din stemmeassistent.
Med det praktiske, regnsikre IPX2-certificerede design kan du nyde din musik når som helst – uanset vejret.
Bekvemmelighed lige ved hånden. Aktivér alle lydfunktioner med den nemme touch-betjening, og få adgang til din stemmeassistent, direkte fra dine JBL Vibe 300TWS-øretelefoner.
FAQs & How-Tos
3 results
-
As with all in-ear headphones, our range of True Wireless Stereo headphones can be susceptible to a build up of dust and earwax. This can cause low volume on one or both earbuds, or balance issues (e.g. right earbud is louder than the left earbud). To reduce the likelihood of these issues occurring, it is a good idea to periodically clean your earbuds. Clean the earbuds by removing dust and wax after each use, using a pointed toothpick to remove larger amounts and a small amount of rubbing alcohol applied to a cotton swab for final degreasing. Remember to clean the charging points on the headphones and inside the charging case.
If you are experiencing volume or balance issues, always check for wax and dirt in and around the earbud and driver and complete cleaning of the earbuds as described above. If the issue persists, there may be earwax/dirt stuck in the small holes in the grille in front of the driver, preventing sound output. To resolve the issue try dipping the affected earbud tip into a solution of lukewarm tap water and a small amount of dish soap (washing up liquid). The earbud tip should only be put into the liquid up to a maximum depth of 1-2 mm only (see images below). Immersing the earbuds in water or putting the earbuds in water at a larger depth than this could void your warranty. Keep the earbud tip in the water for about 2-3 minutes, then wipe/clean the grille with a small brush (such as a toothbrush). This should remove the wax and resolve the volume/balance issues.
Was this helpful? Thank you for your feedback! -
Double-tap the button on the right earbud, then on the third tap - press and hold the button for more than 5 seconds (until the unit shuts off).
This restores the earbuds to the factory defaults.
TWS must be connected to perform the reset, so neither of the earbuds should be off or in the charging case.
It also may be necessary to remove or forget the earbuds from the list of paired Bluetooth devices in order to pair again.Was this helpful? Thank you for your feedback! -
If you are having trouble pairing your headphones or if your device is asking for a PIN, please make sure to check all available BT connections in your device's settings. Verify that you are connecting to the headphone's product name that excludes 'LE'. The 'LE' connection is only intended for voice assistant feature compatible with your headphones. If the voice assistant feature has not yet been configured, this would explain why the 'LE' connection appears as an available connection, but cannot be used for Bluetooth audio.
https://harman.widen.net/s/dtsldx6jxx/bluetooth-pairing-issue-with-voice-assistant-headphone-le-image1Was this helpful? Thank you for your feedback!
Images & Videos
Can’t find what you’re looking for?
Chat with us
Monday - Friday: 09.00-18.00
Saturday - Sunday: 10:00-16:00
