Adapt+

Streaming via Bluetooth or direct aux in connection are supported without the HK Controller app. For OMNI+ devices that you already have placed in a room, they are capable of using either Spotify Connect or Chromecast built-in without the need of using the HK Controller app. Use only the HK Controller app for setting up any OMNI+ devices you may have.

The ADAPT+ is made to connect an external subwoofer. The subwoofer needs to be an active device, which means that it must have its own, built-in amplifier.

There is a reset button on the bottom of the Omni+ devices. Press and hold this button for 5 seconds to perform a factory reset of your product. All product settings, Wi-Fi, and Bluetooth connections will be erased. To reset the OMNI 50+ speaker, please do the following: First, press & hold ‘Source’, ‘Vol+’, ‘Vol-‘ buttons at the same time. The Omni 50+ will switched off, indicating that the product was successful reset. Secondly, press ‘power' button to turn on power for the Omni 50+ speaker. Now you can easily set up the product again for your home Wi-Fi network.

On the bottom of your ADAPT+ there is a reset button. Hold it down for 5 seconds, until the round button LED lights up in white. The product is now reset and ready to be set up again.

Close and restart the Google Home app, or restart your phone. Start the Google Home app again, and the speaker should now appear.
 

No, that is not possible. However, you can create a 5.1 wireless surround system to extend your TV or movie sound. All you need is two additional OMNI+ speakers, such as 2 x OMNI 10+, OMNI 20+ or OMNI 50+.

To have the best possible performance for OMNI+ system we advise to have a dual-band router with a powerful chipset and ram for best Wi-Fi performance. This will not only help our products to perform better and more stable, but your other devices at home will have more power and fewer interruptions. Please also be sure that your home Wi-Fi router has Multicast enabled, as our Omni+ system requires this feature enabled in order to work (same goes for Chromecast devices). Always connect our Omni+ system to 5 GHz Wi-Fi whenever possible to limit the risk of devices being slow or interrupted on 2.4GHz Wi-Fi.

If you see this message, you must download the Device Utility app from the Google Play Store. Follow the instructions in the app to activate your speaker, and then return to the Google Home app to complete the setup.
 

If the network does not appear, you can manually type in the network name (SSID) and password to connect.
 

For OMNI BAR+, three sources are available: HDMI (not applicable for ADAPT+), Optical or AUX input. For Adapt+ two sources are available: Optical in/outputs and Analog in/outputs. If you select "Watching movies and TV shows" in the HK controller app for either one of them, you will have a very little delay and good lip sync with the TV for video applications. However, you will not be able to rebroadcast the TV signal to other OMNI+ speakers when selecting this mode. If you select "Listening to music", you will be able to rebroadcast TV signal to other OMNI+ speakers in your house, however, you will have lip sync delay with video material. Select that specific mode if you use HDMI (not applicable for ADAPT+), Optical or AUX for music only. Using Chromecast, Spotify Connect or Bluetooth is not part of these modes. When using one of these streaming methods, you are able to rebroadcast any music source.