How To
How To
-
The distance between wall-mounts centers are: JBL BAR Studio: 45 cm. JBL BAR 2.1: 70 cm. JBL BAR 3.1: 70 cm. JBL BAR 5.1: 61 cm JBL BAR 5.1 Surround: 71.85 cm JBL BAR 9.1: 55,5 cmWas this helpful? Thank you for your feedback!
-
The Frequency response for the Citation series, except the subwoofer, is 50Hz to 20Khz.
Was this helpful? Thank you for your feedback! -
The EQ Button activates a special "wide stereo sound" effect. It does not affect bass settings. Turning EQ On/Off does not reset bass level to default value. User can adjust BASS in the Bass +/- control in the APP.Was this helpful? Thank you for your feedback!
-
JBL Tour One M2 has integrated high fidelity 40mm neodymium speaker drivers for exceptional high-fidelity sound. Each driver is perfectly tuned to deliver deep bass, balanced mid-range and refined high frequencies for the best on-the-go high fidelity audio listening experience. Super soft ear cushions for a comfortable snug fit and perfect seal. Only the best seal will ensure an immersive spatial audio experience in perfect silence. Use your device for the ultimate high resolution listening experience via Apple Music, Tidal Masters or Amazon Music Unlimited. Immerse yourself fully in spatial audio from any 2-channel audio source via Bluetooth with the JBL Spatial sound technology.
Was this helpful? Thank you for your feedback! -
Software version v.7.9 is the latest for the Flip 3Was this helpful? Thank you for your feedback!
-
JBL Bar 9.1 is 884 mm (without the surrounds in charging position). Surrounds add approx. 160 mm on each side, in charging position.Was this helpful? Thank you for your feedback!
-
The length from the Aux connector to the bottom of the button panel (cable only, excluding the connector and button panel) is approximately 90 cm.
The length of the cable that goes from the top of the button panel to the bottom of each earbud (cable only, excluding the earbuds and button panel) is approximately 29 cm.
The length of the earbuds are approximately 2 cm.
The length of the button panel is approximately 6.5 cm.
The overall total length is approximately = 127.5 cm.
Was this helpful? Thank you for your feedback! -
The maximum video resolution of the No. 40 HDMI card is 1080i.Was this helpful? Thank you for your feedback!
-
The No.536 has several operational and standby modes - the measurements below represent typical values measured at 120VAC: Mode Typical Power Consumption Notes On 210 Watts With no input or output loading Normal (standby) 4.1 Watts/100 Watts Unpon initial power-up/After first use Power Save (Standby) 4.1 Watts Green (Standby) 0.3 Watts OFF 0 Watts Via rear panel switch Note that the No. 536 cannot be shut off by the front button – this is used only for switching the amp in/out of a standby mode. Also note that when set to the Normal standby mode, the amplifier will initially consume the same power as when in the Powersave mode but will change to a higher level after it is switched on for the first time.Was this helpful? Thank you for your feedback!
-
The No. 585 will deliver 350 watts into 4 ohmsWas this helpful? Thank you for your feedback!
-
The overall power rating is 630 W maximum power at 1% THD.
Was this helpful? Thank you for your feedback! -
With the speaker ON, press and hold the VOL+ and Pause/Play buttons for 5-6 seconds. The Xtreme shuts down, and is now reset. You will need to 'forget' the speaker in Bluetooth settings on your phone/tablet in order to pair it again.Was this helpful? Thank you for your feedback!
Can’t find what you’re looking for?
Chat with us
Monday – Friday: 08.00-17.00
Saturday – Sunday : 09.00–15.00
WhatsApp Us
Send us a message on +44 161 222 3325 or click here
Monday - Friday: 08.00-17.00Saturday - Sunday: 09:00-15:00