How To
How To
-
The length from the Aux connector to the bottom of the button panel (cable only, excluding the connector and button panel) is approximately 90 cm.
The length of the cable that goes from the top of the button panel to the bottom of each earbud (cable only, excluding the earbuds and button panel) is approximately 29 cm.
The length of the earbuds are approximately 2 cm.
The length of the button panel is approximately 6.5 cm.
The overall total length is approximately = 127.5 cm.
Was this helpful? Thank you for your feedback! -
The maximum video resolution of the No. 40 HDMI card is 1080i.Was this helpful? Thank you for your feedback!
-
The No.536 has several operational and standby modes - the measurements below represent typical values measured at 120VAC: Mode Typical Power Consumption Notes On 210 Watts With no input or output loading Normal (standby) 4.1 Watts/100 Watts Unpon initial power-up/After first use Power Save (Standby) 4.1 Watts Green (Standby) 0.3 Watts OFF 0 Watts Via rear panel switch Note that the No. 536 cannot be shut off by the front button – this is used only for switching the amp in/out of a standby mode. Also note that when set to the Normal standby mode, the amplifier will initially consume the same power as when in the Powersave mode but will change to a higher level after it is switched on for the first time.Was this helpful? Thank you for your feedback!
-
The No. 585 will deliver 350 watts into 4 ohmsWas this helpful? Thank you for your feedback!
-
The overall power rating is 630 W maximum power at 1% THD.
Was this helpful? Thank you for your feedback! -
With the speaker ON, press and hold the VOL+ and Pause/Play buttons for 5-6 seconds. The Xtreme shuts down, and is now reset. You will need to 'forget' the speaker in Bluetooth settings on your phone/tablet in order to pair it again.Was this helpful? Thank you for your feedback!
-
Speakers will dual tweeters gives listeners the ability to have a single speaker to drive two independent channels, ideally stereo left and right. Dual tweeter speakers are usually used for in-ceiling audio applications. They have four terminals (two sets of positives and negatives) used to plug in speaker wires from the amplifier.Was this helpful? Thank you for your feedback!
-
The range is approximately 10 meters, depending on the environment.Was this helpful? Thank you for your feedback!
-
The Omni 50+ rated power with AC power connected is 4 X 25 Watt. When using battery only, the rated power is 4 X 15 Watt.Was this helpful? Thank you for your feedback!
-
Both the OMNI BAR+ and its subwoofer have 200W of power amplification, which means that total system power is 400 W.Was this helpful? Thank you for your feedback!
-
These are the supported languages for the Everest GA series.
- English (US, UK, CA, IN, AU)
- German
- French (CA, FR)
- Japanese
- Portuguese (BR)
Was this helpful? Thank you for your feedback! -
You can connect the JBL Smart Tx to any audio source to elevate your wireless sound experience. Use the USB-C cable to connect to a digital audio source such as a phone, tablet or laptop or use the 3.5mm aux to connect to an inflight entertainment system on most airplanes, TV or PC to experience wireless audio.
The Smart Tx gives you full access to the Tour One M3 via the touch screen without the need for your phone or app. The Smart Tx can also stream your audio to any Auracast enabled supported headphones or speakers.
Was this helpful? Thank you for your feedback!
Can’t find what you’re looking for?
Chat with us
Monday – Friday: 08.00-17.00
Saturday – Sunday : 09.00–15.00
WhatsApp Us
Send us a message on +44 161 222 3325 or click here
Monday - Friday: 08.00-17.00Saturday - Sunday: 09:00-15:00