How To
How To
1677 results
-
The sensor is located in the LEFT ear bud. The left enhancer will feature a cut out for the sensor and should be fully exposed.Was this helpful? Thank you for your feedback!
-
The heart rate sensor is located inside the RIGHT earbud inside the sound tunnel. If the Heart Rate detection is activated and you remove the RIGHT earbud, the audio voice will notify you to insert the ear bud and will recalibrate once it is detected again.Was this helpful? Thank you for your feedback!
-
Under the little hole next to the phone reciever button.Was this helpful? Thank you for your feedback!
-
On the BT and ELITE NXT series over-ear and on-ear models, the serial number sticker is on the inside of the headband left side, visible when the size adjustment is pulled all the way out. Serial numbers are also shown on the boxes. On ELITE 100 in-ear, it is on the box only.Was this helpful? Thank you for your feedback!
-
The Serial Number is located on the strap hook (see image below), it may be necessary to remove the strap to see it clearly.Was this helpful? Thank you for your feedback!
-
It is a tiny white sticker, located on the inside of the left-hand size adjustment slider on E35.Was this helpful? Thank you for your feedback!
-
The soundbar support SBC codec.Was this helpful? Thank you for your feedback!
-
Our LINK BAR supports the following:
MP3, AAC-LC, HE+ACC, FLAC, Vorbis, Wav, CELT/opus via Wi-Fi streaming, and with Bluetooth SBC and AAC.Was this helpful? Thank you for your feedback! -
The Harman Kardon Aura Studio 2 features: Bluetooth v.4.1 A2DP v.1.3 AVRCP v.1.5Was this helpful? Thank you for your feedback!
-
C-Media 6632A ProcessorWas this helpful? Thank you for your feedback!
-
The JBL Tour One M2 supports AAC and SBC.
LC3 codec will be enabled in 2025 for Bluetooth LE audio connections with a firmware upgrade.
Was this helpful? Thank you for your feedback! -
For OMNI BAR+, three sources are available: HDMI (not applicable for ADAPT+), Optical or AUX input. For Adapt+ two sources are available: Optical in/outputs and Analog in/outputs. If you select "Watching movies and TV shows" in the HK controller app for either one of them, you will have a very little delay and good lip sync with the TV for video applications. However, you will not be able to rebroadcast the TV signal to other OMNI+ speakers when selecting this mode. If you select "Listening to music", you will be able to rebroadcast TV signal to other OMNI+ speakers in your house, however, you will have lip sync delay with video material. Select that specific mode if you use HDMI (not applicable for ADAPT+), Optical or AUX for music only. Using Chromecast, Spotify Connect or Bluetooth is not part of these modes. When using one of these streaming methods, you are able to rebroadcast any music source.Was this helpful? Thank you for your feedback!
Can’t find what you’re looking for?
Chat with us
Monday – Friday: 08.00-17.00
Saturday – Sunday : 09.00–15.00