How To
How To
1676 results
-
Yes, on the master speaker (the one with playback buttons), simply press the Reverse and Forward Play buttons at the same time for 3 seconds. Please note that after you have performed the reset procedure, master and secondary speakers are no longer connected. Go to the owner's manual page 4, the section "speaker association", to pair the secondary and master again.Was this helpful? Thank you for your feedback!
-
If you want to change Bluetooth source, you may have to reset the Bluetooth system in the AURA. To do this, hold your finger on the input selector field (circle with arrow pointing in) on the side of your AURA for at least 3 seconds. Now the previous source is deleted, and you can pair a new source and play from it.Was this helpful? Thank you for your feedback!
-
Yes, when unit is on, press and hold Source and Power buttons for about 6-7 seconds.Was this helpful? Thank you for your feedback!
-
No, the pads are glued to the headphone body, and must be replaced by a service technician.Was this helpful? Thank you for your feedback!
-
Yes, the ear pads are replaceable by owner. The pads can be purchased as spare parts from the service center, or purchased directly from the JBL spare parts web shop, when opened.Was this helpful? Thank you for your feedback!
-
It is possible to replace the ear pads, but there are details to consider. On Elite 700: The ear pads are held in place by a plastic plate with claws, and some of the claws will most likely break off when you remove the pad. You do this by grabbing under the edge where the fabric ends, then pulling hard outward. The claws will eventually let go, and some of them will break off, rattling inside the ear pod. The only way to get them out is to unscrew the speaker plate, lift it up, and shake out the broken-off claws. The new pads are simply centered over the speaker plate, and the claws pressed into the holes with a firm pressure. On Everest 700: The ear pads are glued into position with double-adhesive tape. Pull the old pads off with a forceful, steady pull, until the glue lets go. Remove the protective layer on the new pads, and carefully position them correctly before pressing home all the way around the edge.Was this helpful? Thank you for your feedback!
-
Yes, the smooth leather headband from the K601 can be fitted onto the K701, but since it is probably no longer available as a spare part, the only option is to butcher an old 601 to do it. The work involved is very intricate and complicated, and paying a technician to do it is not an economical solution. Owner must be capable of completely dismantling the headphones, including soldering, and to reassemble them. And Harman cannot offer any assistance in doing this. As of late 2017, a new version of K701 is being marketed by AKG Professional. This version features a smooth headband instead of the version with bumps, so the issue no longer applies.Was this helpful? Thank you for your feedback!
-
Yes, use the MONITOR OUT sockets (1/4” and RCA are available on 208P, RCA on ONE) to feed into a recording device. Please note that these outputs are volume controlled, so set the volume correctly, depending on the sensitivity of the recording device.Was this helpful? Thank you for your feedback!
-
Yes. Out-the-box the JBL Bar series soundbar recognizes volume and mute controls from the most common TV remote controls. The JBL Bar series has IR learning. You can use this feature to teach the soundbar to response to your TV's remote control as well.Was this helpful? Thank you for your feedback!
-
Yes, Zone 2 can play compatible contents of a USB stick inserted into the front panel of the receiver.Was this helpful? Thank you for your feedback!
-
Yes, you can play game either wired or wirelessly while using USB-C charging cable.Was this helpful? Thank you for your feedback!
-
The JBL Quantum Stream Studio comes with an adapter that can be mounted on different boom mic arm systems or tripods. The adapter is already built in the microphone stand so that you always have the adapter close to you when needed.
Was this helpful? Thank you for your feedback!
Can’t find what you’re looking for?
Chat with us
Monday – Friday: 08.00-17.00
Saturday – Sunday : 09.00–15.00