JBL Quantum Stream Studio
USB streaming microphone
Sold from 2023 until now
Getting started with your JBL Quantum Stream Studio
Quick Start Guide
Get up and running in no time with our easy-to-follow Quick Start Guide
Register your product
Do you own this product? Register it here! And claim your warranty or service easily
Register nowDocuments & Downloads
Specifications
- Power required/consumption
- 5 V ⎓ 500 mA
- Frequency response
- 50 Hz - 16 kHz
- Sensitivity
- -37±3 dB (1 kHz@1 Pa, 0 dB = 1 v/Pa)
- Maximum SPL
- 110 dB
- Sample rates
- 44.1kHz / 48 kHz / 96 kHz / 192 kHz
- Bit rate
- 16 / 24 bits
- Capsules
- 3 * 14 mm Electret Condenser Microphones
- Polar patterns
- Cardioid, omnidirectional, stereo, bi-directional
- Headphones Amplifier Impedance
- 16 ohms / 32 ohms
- Headphones Power output (RMS)
- 42 mWrms per channel (Load = 32 ohms)
- Headphones THD
- <0.5% (Load = 32 ohms)
- Headphones Frequency response
- 20 Hz - 20 kHz
- Headphones Signal to noise
- 92 dB with 48kHz sample rate, 93dB with 192kHz sample rate (A-weighted)
- Weight Mic with Stand
- 582 g / 1.283lbs
Sound is survival Let your voices be heard
Sound like a pro with the JBL Quantum Stream Studio microphone. Whether you're gaming, streaming or recording by yourself, with a co-host, or with a roomful of guests, you can quickly switch between four different pickup patterns so that everyone can be heard. No additional gear required to level up your game. You'll always know how loud things are getting thanks to the RGB VU meter, and the dynamic range compressor makes sure everyone's voice stays at the same level. Streaming a game? Fully control the balance between the game sounds and your own commentary. Use the included JBL QuantumENGINE PC software to adjust EQ, apply noise reduction, or customize the mic's radiant RGB lighting.
FAQs & How-Tos
-
The JBL Quantum Stream Studio comes with an adapter that can be mounted on different boom mic arm systems or tripods. The adapter is already built in the microphone stand so that you always have the adapter close to you when needed.
Was this helpful? Thank you for your feedback! -
You can clean it by wiping it gently with a damp cloth. Take extra care not to let water leak into the speaker chamber, as it will damage the speaker drivers.Was this helpful? Thank you for your feedback!
-
You can clean it by wiping it gently with a damp cloth. Take extra care not to let water leak into the speaker chamber, as it will damage the speaker drivers.Was this helpful? Thank you for your feedback!
-
Sidetone is by default enabled for the JBL Quantum Stream Studio. You can lower the sidetone volume or mute it by pressing the multifunction knob until you are at the audio/voice balance function. Turn the knob towards the voice (microphone icon) to increase the audio volume and lower down the sidetone volume at the same time. Turn the knob towards the headphone icon to increase the sidetone volume and reduce the audio volume.
Was this helpful? Thank you for your feedback! -
To reset a Quantum headset, you need to connect the product to your computer and open the QuantumEngine.
When you have the QuantumEngine open, go to the "System Software" tap and press "Restore Factory Settings".
Only products that are compatible with the QuantumEngine can be reset this way.
Was this helpful? Thank you for your feedback! -
Try to move the microphone closer to the sound source and adjust it for a better angle. You should also try to decrease the microphone volume to an appropriate level by turning the volume down.
Finally, try to enable the Dynamic Range Compressor (DRC) option in the QuantumEngine to lower the chance of distortion.
Was this helpful? Thank you for your feedback! -
Try to move the microphone closer to the sound source and adjust it for a better angle. You should also try to increase the microphone volume to an appropriate level by turning the volume up.
Finally, try to increase or decrease the microphone gain level if the sound is distorted.Was this helpful? Thank you for your feedback! -
In every microphone there are polar patterns that describes the microphone directionality. Different polar patterns describe how well the microphone module picks up sound waves coming from different directions.
There are four different polar patterns which can be used for different situations. The Cardioid pattern is the best option when you are recording on your own. The Omni-directional pattern is the most suitable for recordings with multiple people from different directions. The Stereo pattern is most optimal when two people are sitting next each other or playing an instrument during a recording. The bidirectional pattern works the best when two people are sitting opposite each other.
Was this helpful? Thank you for your feedback! -
The JBL Quantum Stream microphone is compatible with the JBL QuantumENGINE software. You can customize or use the following settings/features via the JBL QuantumENGINE:
Microphone settings
Polar patters (Cardioid / Onnidirectional)
Equalizer
RGB LED Light colors + animations/effects
Update firmware + softwareWas this helpful? Thank you for your feedback! -
You can customize or use the following settings/features via the JBL QuantumENGINE:
Microphone settings
Polar Patterns (Directions that the Quantum Stream Studio picks up the sound)
Equalizer
Lighting settings
Update firmware and software
Was this helpful? Thank you for your feedback!
Images & Videos
Can’t find what you’re looking for?
Chat with us
Monday – Friday: 08.00-17.00
Saturday – Sunday : 09.00–15.00
WhatsApp Us
Send us a message on +44 161 222 3325 or click here
Monday - Friday: 08.00-17.00Saturday - Sunday: 09:00-15:00