Omni 20 Plus

Yes, with OMNI+ you can add speakers to both bands, but your smart device is not required to be on the same band, just be sure they are on the same network.

No, stereo pairs must be two of the same type of speaker. For example, two Omni 10 or two Omni 10+ speakers will work, but not one Omni 10 and one Omni 10+.

Streaming via Bluetooth or direct aux in connection are supported without the HK Controller app. For OMNI+ devices that you already have placed in a room, they are capable of using either Spotify Connect or Chromecast built-in without the need of using the HK Controller app. Use only the HK Controller app for setting up any OMNI+ devices you may have.

There is a buffer inside the speakers that processes the incoming signal. This buffer delays the audio signal compared to the video signal, causing a delay. For this, we do not recommend using Omni+ speakers with a TV. Our Omni bar will work with your TV sound and you can create wireless 5.1 surround sound system with the Omni bar.

Every home is different, so it is difficult to provide a universal guide that suits it all. What you can do is check the number of available access points in your home by performing a Wi-Fi network scan using a mobile device. Then select the Wi-Fi channel that isn't as busy as the rest. Also, check how much noise each speaker has using the Harman Kardon Controller app. Simply go into the settings menu and select "Send us feedback" to see the results, signals between -40 dB and -62 dB are considered good.

There is a reset button on the bottom of the Omni+ devices. Press and hold this button for 5 seconds to perform a factory reset of your product. All product settings, Wi-Fi, and Bluetooth connections will be erased. To reset the OMNI 50+ speaker, please do the following: First, press & hold ‘Source’, ‘Vol+’, ‘Vol-‘ buttons at the same time. The Omni 50+ will switched off, indicating that the product was successful reset. Secondly, press ‘power' button to turn on power for the Omni 50+ speaker. Now you can easily set up the product again for your home Wi-Fi network.

We recommend starting playback on the Omni+ speaker first, and then linking the 1st generation Omni speakers. Omni+ is more powerful and can provide more stability when restreaming to other speakers.

Make sure you disable AP/Client isolation on your Access Point / Extender and that Multicast forwarding is not disabled between the W-Fi networks. However, we cannot guarantee than streaming will work flawless as Extender networks are tricky and can cause many issues. Always use a 5GHz Wi-Fi network extender for best results.

If you are having problems playing music after setting up a new speaker (no matter what connection is used, Ethernet, Wi-Fi), please restart the Harman Kardon Controller app after the speaker setup is complete.

If you are experience this message, please power cycle the Wi-Fi router and speaker(s). Disconnect the devices' power cable for 10 seconds and then reconnect them. Once the router and speaker(s) completely boots up, please try to setup again.