KAPPA 1 (ONE)

KAPPA 1 (ONE)

800 Watt Class-D Mono Subwoofer Amplifier

Vendido desde 2008 hasta ahora

Documentos y descargas

Especificaciones del producto

Signal-to-noise ratio
85dBA (1W/4 ohms)*
Signal-to-noise ratio
112dBA (rated power into 4 ohms)
Frequency response
20Hz – 320kHz (–3dB)
Dimensions (L x D x H)
329mm x 179mm x 44mm
CEA Rated
Yes
Amplifier Power (RMS)
800 watts x 1 channel @ 2 ohms and ≤1% THD + N
Signal-to-Noise Ratio
85dBA (reference 1 watt into 4 ohms)
Frequency Response
20Hz – 320Hz (-3dB)
Effective Damping Factor
6.3 @ 4 ohms
Maximum Input Signal
6V
Input Sensitivity
MAXIMUM... 200mV
MSRP U.S.
$549.95 each
Dimensions
13 inch Long x 7-1/16 inch Wide x 1/3/4 inch High

800 Watt Class-D Mono Subwoofer Amplifier with on-board electronic crossover and DBO (Dynamic Bass Optimization Circuit). Its compact footprint is only 13 inch x 7-1/16 inch x 1-3/4 inch, making it idea for tight installations.

Kappa amps feature high-power Class D circuit topology with DirectFET® transistors, a design that increases power output and overall efficiency, with improved heat transfer from the transistors to the chassis.
DBO is a proprietary variable subsonic filter with variable bass boost. Unlike conventional fixed-frequency filters, DBO conserves power at frequencies below 100Hz, protecting woofers in vented-box applications from overexcursion, and flattening response through the lowest octaves in sealed-box and infinite-baffle applications.
Kappa amps use differential-signal inputs with high common-mode noise rejection for all speaker-level and line-level outputs from source units. Because noise from the vehicle’s alternator and other electrical components is radiated into the positive and negative leads of each signal input equally, amplifying the difference between the leads effectively cancels out the noise, leaving only the music.
Kappa amps feature smart circuitry to protect your speakers in the event of short circuits or problems with your battery, alternator or voltage regulator. They also protect themselves against excess heat, with circuits that cool the amplifier down by gradually reducing output without shutting it down completely.
At just 1-3/4" high, Kappa amps will fit under most seats.

¿No encuentras lo que buscas?

Llámanos

Llámanos

Habla con un experto sobre nuestros productos
Llámanos a este número: 55-5328-1023

Lunes - Viernes: 09:00 AM -06:00 PM (Hora Centro)

Envíanos un correo electrónico

Envíanos un correo electrónico

¡Estamos aquí de lunes a viernes para responder sus correos lo antes posible!

Envíanos un correo electrónico
message