MA 6004
4-Channel Full-Range Marine Amplifier (60x4)
Såld från 2006 tills nu
| Tillverkade i: | China |
|---|
Komma igång med din $produkt
Registrera din produkt
Äger du den här produkten? Registrera dig här! Och gör anspråk på din garanti eller service på ett enkelt sätt
Registrera nuDokument och hämtningar
Produktspecifikationer
- Series
- Marine
- Type
- 4-Channel
- Amplifier Power (RMS)
- 60 watts x 4 channel @ 4 ohms and ≤1% THD + N
- Signal-to-Noise Ratio
- 86dBA (reference 1 watts into 4 ohms)
- Dynamic Power
- 145 watts @ 2 ohms
- Effective Damping Factor
- 6.39 @ 4 ohms
- Frequency Response
- 10Hz – 27kHz (-3dB)
- Maximum Input Signal
- 6.0V
- Input Sensitivity
- MAXIMUM... 100mV
- MSRP U.S.
- $169.95 each
- Input Sensitivity
- 100mV
- Signal-to-Noise Ratio
- 80dBA
- Damping Factor
- 6.395 at 4 ohms
- Dynamic Power Output
- 145W at 2 ohms
- Dimensions
- 2.2 inch x 13 inch x 10.3 inch
4-Channel Full-Range Marine Amplifier with electronic crossover, variable bass bosst and preamp outputs.
With a marinized circuit board, stainless-steel hardware and all the right waterproofing, the MA6004 is, like all JBL® marine audio products, built to survive salt water, corrosion and other risks – and show you a great time out on the water.
The JBL® MA6004 has onboard 12dB electronic crossovers, giving you tuning options for systems of any size. Versatility, convenience and ease of use are all part of the JBL way of sound.
Your boat may give you a choice of where to install your sound system, or it may not. Fortunately, the MA6004’s variable bass-boost circuit provides additional bass tuning to optimize performance, regardless of where it lives.
Owning a boat takes commitment and work. Installing the JBL® MA6004? Not so much. It’s also pretty compact at 13-1/4" x 10-1/4" x 2-3/16" (337mm x 261mm x 56mm) with a low-profile heatsink. You can put it in some very tight spots.
The JBL® MA6004 has output of 60 watts RMS X 4 channels at 4 ohms. You can fill the fresh, open air with great sound.
The MA6004 comes equipped with a separate 12dB Per Octive Electronic Crossover for front and rear channels. This provides a high level of tunablity and allows for different speakers to be connected to the front channels and rear channels. Both crossovers are setep to allow for either high-pass or low-pass.
The front and rear channels are also equipped with a separatae variable bass boost for the front channels and rear channels. There is a total of 6dB of boost available centered at 45Hz.
The MA6004 has a preamp output which allows a full range signal to be passed on to additional amplifiers.
Bilder och videor
Hittade du inte det du sökte efter?
Skicka e-post till oss
Vi är här måndag-fredag för att svara på ditt mejl så fort vi kan!
Chatta med oss
Chatta på engelska:
Måndag – fredag: 09:00-18:00
Lördag – söndag: 10:00-16:00
WhatsApp oss
WhatsApp-support endast på engelskaSkicka ett meddelande till oss på engelska här
Måndag – fredag: 09.00-18.00Lördag – söndag: 10:00-16:00