JBL REFLECT MINI 2

Documents & Downloads

FAQs & How-Tos

8 results

Sort

Page size

Does this headphone feature the automatic shut off?

No, the Reflect Mini BT does not feature the automatic shut off.

Was this helpful? Thank you for your feedback!
How can I reset my JBL headphones?

With the headphones switched ON, press and hold the Volume + and Volume - buttons for more than 5 seconds. The LED blinks two colors, and now you have reset to factory settings.

Was this helpful? Thank you for your feedback!
How do I turn off the Reflect Mini BT?

Press and hold the center power button that is located on the inline microphone. You will see the flashing LED blue light turn off on top of the volume increase button on the microphone.

Was this helpful? Thank you for your feedback!
How do you skip tracks?

The REFLECT MINI BT lets you skip the tracks forward, by pressing and holding the volume up button for 3 seconds and skip tracks backward, by pressing and holding the volume down button for 3 seconds.

Was this helpful? Thank you for your feedback!
How to avoid Bluetooth Interference or Interruptions

• Always have clear line of sight between your Bluetooth device (speaker, headphones etc.) and source device (Smartphone/tablet/PC etc). Be aware of obstacles in front of your devices.

• Try to shutdown other products that have Bluetooth, but are not being used. They are often the reason for interference even though they are not being used.

• Do not stand too close to your Wi-Fi router since a Wi-Fi signal is stronger and in many cases will "overlap" the connection.

• Be aware of walls around you. Concrete and brick walls will often interrupt the signal, as it cannot pass through such thick walls.

• Bluetooth signals cannot travel through water, which includes the human body. Make sure with wireless headphones to keep your source device and the receiver on the same side of your body.

• Open spaces such as parks can cause issues for your devices, as open air is "bad" for any Bluetooth signal if it cannot reflect from objects around you.

Was this helpful? Thank you for your feedback!
Is it possible to turn off the blinking blue LED light from my headphones?

No. There is no way to turn off the blue LED light from our wireless headphones unless they are turned off.

Was this helpful? Thank you for your feedback!
Reflect Mini 2: Pairing Information

To connect to a different Bluetooth device, first switch the headphones off. Now press and hold the center button on the headphone remote control for about 3-5 seconds. You should see the light blinking red/blue to indicate pairing mode, and the voice prompt should state “looking for device”. You should see "Reflect Mini 2" appear on the source's BT list. Choose that option, and wait for the voice prompt to state “connected”

Was this helpful? Thank you for your feedback!
What does the LED light show during charging?

During charging, the LED lights red constantly. When it is fully charged, the LED goes out. No light.

Was this helpful? Thank you for your feedback!