How To
How To
1869 results
-
Apart from the driver materials, both the Studio 2 and Arena architectural speakers are quite the same. However, the Studio 2 series does deliver better high frequency versatility, thanks to the pivoting and level adjusting feature for the tweeter. The pivoting feature allows you to position/direct the tweeter toward the listening area. The level adjusting feature allows you to tune the high frequency (Zero to -3dB) as needed. These features are also available on select Harman Luxury Architectural speakers (Revel) as well.Was this helpful? Thank you for your feedback!
-
The distance between wall-mounts centers are: JBL BAR Studio: 45 cm. JBL BAR 2.1: 70 cm. JBL BAR 3.1: 70 cm. JBL BAR 5.1: 61 cm JBL BAR 5.1 Surround: 71.85 cm JBL BAR 9.1: 55,5 cmWas this helpful? Thank you for your feedback!
-
Playing time is up to 20 hours.Was this helpful? Thank you for your feedback!
-
The Frequency response for the Citation series, except the subwoofer, is 50Hz to 20Khz.
Was this helpful? Thank you for your feedback! -
The EQ Button activates a special "wide stereo sound" effect. It does not affect bass settings. Turning EQ On/Off does not reset bass level to default value. User can adjust BASS in the Bass +/- control in the APP.Was this helpful? Thank you for your feedback!
-
Software version v.7.9 is the latest for the Flip 3Was this helpful? Thank you for your feedback!
-
JBL Bar 9.1 is 884 mm (without the surrounds in charging position). Surrounds add approx. 160 mm on each side, in charging position.Was this helpful? Thank you for your feedback!
-
The same as the 8 ohm output, 125 watts/channel.Was this helpful? Thank you for your feedback!
-
Wireless Dual Sound feature supports a maximum of two speakers. Both the GO + PLAY MINI and the other speaker must have the Dual Sound feature.Was this helpful? Thank you for your feedback!
-
The maximum video resolution of the No. 40 HDMI card is 1080i.Was this helpful? Thank you for your feedback!
-
The No.536 has several operational and standby modes - the measurements below represent typical values measured at 120VAC: Mode Typical Power Consumption Notes On 210 Watts With no input or output loading Normal (standby) 4.1 Watts/100 Watts Unpon initial power-up/After first use Power Save (Standby) 4.1 Watts Green (Standby) 0.3 Watts OFF 0 Watts Via rear panel switch Note that the No. 536 cannot be shut off by the front button – this is used only for switching the amp in/out of a standby mode. Also note that when set to the Normal standby mode, the amplifier will initially consume the same power as when in the Powersave mode but will change to a higher level after it is switched on for the first time.Was this helpful? Thank you for your feedback!
-
The No. 585 will deliver 350 watts into 4 ohmsWas this helpful? Thank you for your feedback!
-
The overall power rating is 630 W maximum power at 1% THD.
Was this helpful? Thank you for your feedback! -
With the speaker ON, press and hold the VOL+ and Pause/Play buttons for 5-6 seconds. The Xtreme shuts down, and is now reset. You will need to 'forget' the speaker in Bluetooth settings on your phone/tablet in order to pair it again.Was this helpful? Thank you for your feedback!
-
Speakers will dual tweeters gives listeners the ability to have a single speaker to drive two independent channels, ideally stereo left and right. Dual tweeter speakers are usually used for in-ceiling audio applications. They have four terminals (two sets of positives and negatives) used to plug in speaker wires from the amplifier.Was this helpful? Thank you for your feedback!
-
The audio level adjustment is a dedicated control for adjusting the tweeter’s high frequency volume. It allows you attenuate up to 3dB, based on your environment and/or preference.Was this helpful? Thank you for your feedback!
-
The range is approximately 10 meters, depending on the environment.Was this helpful? Thank you for your feedback!
-
The Omni 50+ rated power with AC power connected is 4 X 25 Watt. When using battery only, the rated power is 4 X 15 Watt.Was this helpful? Thank you for your feedback!
-
Both the OMNI BAR+ and its subwoofer have 200W of power amplification, which means that total system power is 400 W.Was this helpful? Thank you for your feedback!
-
These are the supported languages for the Everest GA series.
- English (US, UK, CA, IN, AU)
- German
- French (CA, FR)
- Japanese
- Portuguese (BR)
Was this helpful? Thank you for your feedback! -
This connection is intended for software and service updates only.Was this helpful? Thank you for your feedback!
-
Voltage is 100 - 240 Volt AC. Maximum power consumption is 120 Watts.Was this helpful? Thank you for your feedback!
-
Soundgear Sense provides two wearing styles, either as regular TWS headphones with an ear hook for a secure fit, or as a neckband headphone with the optional detachable neckband. Both wearing styles offer the same open ear experience with rich, full-range sound, it is just a matter of your own preference or use case which wearing style you choose.
Was this helpful? Thank you for your feedback! -
Now, with Google Assistant and Alexa available simultaneously on your JBL Authentics speakers, you can choose to use one or both voice services available. This means you can set up just Alexa, just Google Assistant, or both. If you choose to set up both services, they will be at the ready. You can use either of them whenever you want simply by saying either “Hey Google” or “Alexa”.
Was this helpful? Thank you for your feedback!
Can’t find what you’re looking for?
Call Us
Talk to a product expert
Call Us now at:
(877) 871-6755
Mon - Fri: 9:00 am - 11:00 pm (ET)
Sat - Sun: 9:00 am - 5:00 pm (ET)
Chat with Us
Mon - Fri: 9:00 am - 11:00 pm (ET)
Sat - Sun: 9:00 am - 5:00 pm (ET)
Text Us
Text with a support agent via SMS at:
628-333-7807
Mon - Fri: 9:00 am - 11:00 pm (ET)
Sat - Sun: 9:00 am - 5:00 pm (ET)