How To
How To
1874 results
-
The maximum video resolution of the No. 40 HDMI card is 1080i.Was this helpful? Thank you for your feedback!
-
The No.536 has several operational and standby modes - the measurements below represent typical values measured at 120VAC: Mode Typical Power Consumption Notes On 210 Watts With no input or output loading Normal (standby) 4.1 Watts/100 Watts Unpon initial power-up/After first use Power Save (Standby) 4.1 Watts Green (Standby) 0.3 Watts OFF 0 Watts Via rear panel switch Note that the No. 536 cannot be shut off by the front button – this is used only for switching the amp in/out of a standby mode. Also note that when set to the Normal standby mode, the amplifier will initially consume the same power as when in the Powersave mode but will change to a higher level after it is switched on for the first time.Was this helpful? Thank you for your feedback!
-
The No. 585 will deliver 350 watts into 4 ohmsWas this helpful? Thank you for your feedback!
-
The overall power rating is 630 W maximum power at 1% THD.
Was this helpful? Thank you for your feedback! -
With the speaker ON, press and hold the VOL+ and Pause/Play buttons for 5-6 seconds. The Xtreme shuts down, and is now reset. You will need to 'forget' the speaker in Bluetooth settings on your phone/tablet in order to pair it again.Was this helpful? Thank you for your feedback!
-
Speakers will dual tweeters gives listeners the ability to have a single speaker to drive two independent channels, ideally stereo left and right. Dual tweeter speakers are usually used for in-ceiling audio applications. They have four terminals (two sets of positives and negatives) used to plug in speaker wires from the amplifier.Was this helpful? Thank you for your feedback!
-
The audio level adjustment is a dedicated control for adjusting the tweeter’s high frequency volume. It allows you attenuate up to 3dB, based on your environment and/or preference.Was this helpful? Thank you for your feedback!
-
The range is approximately 10 meters, depending on the environment.Was this helpful? Thank you for your feedback!
-
The Omni 50+ rated power with AC power connected is 4 X 25 Watt. When using battery only, the rated power is 4 X 15 Watt.Was this helpful? Thank you for your feedback!
-
Both the OMNI BAR+ and its subwoofer have 200W of power amplification, which means that total system power is 400 W.Was this helpful? Thank you for your feedback!
-
These are the supported languages for the Everest GA series.
- English (US, UK, CA, IN, AU)
- German
- French (CA, FR)
- Japanese
- Portuguese (BR)
Was this helpful? Thank you for your feedback! -
This connection is intended for software and service updates only.Was this helpful? Thank you for your feedback!
Can’t find what you’re looking for?
Call Us
Talk to a product expert
Call Us now at:
(877) 871-6755
Mon - Fri: 9:00 am - 11:00 pm (ET)
Sat - Sun: 9:00 am - 5:00 pm (ET)
Chat with Us
Mon - Fri: 9:00 am - 11:00 pm (ET)
Sat - Sun: 9:00 am - 5:00 pm (ET)
Text Us
Text with a support agent via SMS at:
628-333-7807
Mon - Fri: 9:00 am - 11:00 pm (ET)
Sat - Sun: 9:00 am - 5:00 pm (ET)