How To

Support Overview / How To

How To

1413 results
  • How do I skip tracks on the Everest 750NC?
    To skip the tracks forward, you press and hold the volume up button for 3 seconds. To skip tracks backward, press and hold the volume down button for 3 seconds.
  • How do I skip tracks on the Everest 310/710 headphones?
    To skip the tracks forward, you press and hold the volume up button for 3 seconds. To skip tracks backward, press and hold the volume down button for 3 seconds.
  • How do I set up my Adapt so my existing equipment can play stereo?
    In the Harman Kardon Controller app, set up the Adapt as a stand-alone room, not a stereo pair room. The Adapt always delivers stereo audio via its Audio Out jack.
  • How do I see when the noise cancelling battery of AKG N20NC is empty?
    When less than one hour's capacity is left, the red diode will blink. It will eventually stop blinking, when all power is gone.
  • How do I see when my JBL E45BT or E55BT is fully charged?
    While charging, the charging indicator diode is lighting constantly. When charging is complete, the light goes out.
  • How do I see what is left and right on the AKG N20?
    The L and R that indicate the two channels are located on the soft grommets that protects the signal cable where it enters the headphone shell. The letters are recessed into the grommets, and are very small. If they are too difficult to read, it may be easier to simply observe how the headphones are situated in the ears. The oval body of each in-ear, with the chrome stripe, should be away from the head, and be situated in the ear lobe, not stick out directly from the head.
  • How do I see that battery is low?
    The charging LED on the headset will flash red when the battery is low. For the ELITE models, a more accurate indication of remaining battery time can be seen on the fuel gauge in the app.
  • How do I reset the Endurance Series Headphones?

    For all models except Endurance Peak:
    Press the headphone touch control located on the RIGHT ear loop for 15 seconds while the headphones are being charged.
    Note that resetting the Dive will not erase music contained in the MP3 memory.

    Endurance Peak reset: While the pods are being charged, tap the touch pad on the right pod once, then tap again and hold for approx 18 seconds, or until the LED blinks.

  • How do I reset the device to factory settings?
    Power ON the device, then press and hold the "Volume+" and the "Play/Pause" buttons at the same time. When the device switches off after a few seconds, sounding the OFF prompt, it has been reset.
  • How do I reset the Charge 4?
    In order to reset the Charge 4, with the unit on, press “Volume+” and “Bluetooth” at the same time for 3-4 seconds until you hear the audible chime.
  • How do I reset my JBL headphones?
    With the headphones switched ON, press and hold both volume buttons for more than 5 seconds.
    Your headphones are now reset to factory status.
     
  • How do I reset my JBL Everest 310, 710 and 750 Elite headphones?
    With the headphones switched ON, press VOLUME + and VOLUME - , and hold them for 5 seconds. Your headphones are now reset to factory settings. This is true for Everest 310, 710, Elite 750, 310GA and 710GA.
< 1 ... 71 72 73 74 75 ... 119 >

Can’t find what you’re looking for?

Call us

Call us

To speak to our customer service specialist

1800-102-0525

Mon to Sun 10 AM to 7 PM IST

message

Message Us

Chat with a support agent via Whatsapp at:
91 70658 44446

Mon - Sun: 10:00 am - 7:00 pm (IST)